PEDICURE SPA SPECIFICATIONS
Hot and cold water supply lines required
(hot and cold shut offs may be installed under pedicure spa base)
Drain installation: Unit comes standard with power drain pump.
(See owner’s manual for complete installation instructions.)

SHIPPING INFORMATION
Seat collapsed, armrests closed (spa shipping position):
59"L (150cm) x 33”W (84cm) x 34"H (86cm)
Carton dimensions: 65”L (165cm) x 36W (84cm) x 41”H (165cm)
Weight: 235lbs (107kg)

SPA INFORMATION
Overall dimensions, armrests closed, seat upright and forward:
59"L (150cm) x 33”W (84cm) x 57"H (145cm)
Overall dimensions, armrests open w/cup holders exposed, seat upright & forward: 59"L (150cm) x 46”W (117cm) x 57"H (145cm)
Maximum area required for full chair and armrest movement:
76”L (193cm) x 46”W (117cm) x 57"H (145cm)
Empty weight (complete): 186lbs (83kg)
Water fill line capacity: 5.5 U.S. gallons
Whirlpool pump motor: 110V: 1/6 HP, 110V, 60Hz (alternate voltages available) 220V: 1/6 HP, 220V, 50/60Hz
Seat upholstery: Polyurethane
Seat and back motors: 24V DC Linear Actuators. Spa requires 17” (44cm)
of space between pedicure spa and wall with standard actuator
Brushless roller massage motor: 12V AC, Adapter included (alternate voltages available)
Power source: 110V: 110V AC, 2.75 Amps, 60Hz (GFCI Protected)
220V: 220V AC, 2.75 Amps, 50/60Hz (GFCI Protected)
Caution: Pedicure spa must be installed by a licensed electrician and a licensed plumber, conforming to all local and national electrical codes.
Construction: Metal Frame with Acrylic Shells and basin, pre-plumbed
Crystal Clean™ Pipe-Free® Technology: Six 'underfoot' water massage grooves, no closed loop circulating pipes, 100% fully drained, easy to clean and sanitize.
Electrical switches: On/Off switch for whirlpool pump. A single hand-held,
low voltage remote control for massage motors, heat and seat/back position.
Hot and Cold water supply lines required.
Compliances: TÜV certified ~ Tested according to CAN/CSA-E60335-1:1994,
CAN/CSA-E60335-2-32:2001, UL 60335-1:2002, & UL 1647:2001
lectrostatic limits: This unit may lose one or more functions when electrostatic contact discharge in excess of 4KV gets into accessible conductive part of the unit and can be restored by resetting the unit. This unit may lose one or more functions when power surge in excess of 2KV is applied to the AC input power port and can be restored by resetting the unit.